1. REMOVE DOOR CONTROL RECEIVER (for 5 Door) (Click here) 2. REMOVE DOOR CONTROL RECEIVER (for 3 Door) (Click here) 3. REMOVE RADIO SETTING CONDENSER NOTICE: When the terminal cover is removed, the condenser must be replaced because the terminal cover and condenser are supplied as a set. Remove the bolt. Disengage the clamp and… Read More
2005 – 2013 YARIS NCP93 – CLUTCH (for Hatchback) > RECOMMENDED TOOLS
for Preparation Click here
2005 – 2013 YARIS NCP93 – POWER STEERING ECU (for Hatchback) > COMPONENTS
1 / 1
2005 – 2013 YARIS NCP93 – CANISTER (for Hatchback) > COMPONENTS
1 / 1
2005 – 2013 YARIS NCP93 – POWER DOOR LOCK CONTROL SYSTEM (for Hatchback) > SYSTEM DIAGRAM
2005 – 2013 YARIS NCP93 – AUTOMATIC TRANSAXLE SYSTEM (for Sedan) > DIAGNOSIS SYSTEM
DESCRIPTION When troubleshooting OBD II vehicles, the only difference from the usual troubleshooting procedure is to connect a Techstream (complying with SAE J1987) to the vehicle, and read off various data output by the vehicle’s ECM. OBD II regulations require that the vehicle’s on-board computer illuminate the Malfunction Indicator Lamp (MIL) on the instrument panel… Read More
2005 – 2013 YARIS NCP93 – ENGINE UNIT (for Hatchback) > COMPONENTS
1 / 7 2 / 7 3 / 7 4 / 7 5 / 7 6 / 7 7 / 7
2005 – 2013 YARIS NCP93 – OUTER MIRROR SWITCH (for Sedan) > INSPECTION
1. INSPECT OUTER MIRROR SWITCH Check the resistance. Select L on the left/right adjustment switch. Using an ohmmeter, measure the resistance and check the results in accordance with the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition – OFF 10 kΩ or higher 4 (VL) – 8 (B)6 (M+) – 7… Read More
2005 – 2013 YARIS NCP93 – FRONT DOOR SPEAKER (for Sedan) > COMPONENTS
1 / 2 2 / 2
2005 – 2013 YARIS NCP93 – LIGHTING SYSTEM (for Sedan) > Illumination Circuit
LIGHTING SYSTEM (for Sedan) > Illumination Circuit DESCRIPTION The main body ECU controls the room light assembly. WIRING DIAGRAM INSPECTION PROCEDURE NOTICE: Inspect the fuses and bulbs for circuits related to this system before performing the following inspection procedure. 1.PERFORM ACTIVE TEST USING TECHSTREAM Connect the Techstream to the DLC3. Turn the ignition switch to… Read More